Cassie's law, or the Cassie equation, describes the effective contact angle θc for a liquid on a chemically heterogeneous surface, i.e. the surface of a composite material consisting of different chemistries, that is non uniform throughout.[1] Contact angles are important as they quantify a surface's wettability, the nature of solid-fluid intermolecular interactions.[2] Cassie's law is reserved for when a liquid completely covers both smooth and rough heterogeneous surfaces.[3]

Cassie-Baxter state. A water droplet resting on a heterogeneous surface (sand), forms a contact angle, here

More of a rule than a law, the formula found in literature for two materials is;

where and are the contact angles for components 1 with fractional surface area , and 2 with fractional surface area in the composite material respectively. If there exist more than two materials then the equation is scaled to the general form of;

, with .[4]

Cassie-Baxter edit

Cassie's law takes on special meaning when the heterogeneous surface is a porous medium.   now represents the solid surface area and   air gaps, such that the surface is no longer completely wet. Air creates a contact angle of  and because  =  , the equation reduces to:

 , which is the Cassie-Baxter equation.[5]

Unfortunately the terms Cassie and Cassie-Baxter are often used interchangeably but they should not be confused. The Cassie-Baxter equation is more common in nature, and focuses on the 'incomplete coating' of surfaces by a liquid only. In the Cassie-Baxter state liquids sit upon asperities, resulting in air pockets that are bounded between the surface and liquid.

Homogeneous surfaces edit

The Cassie-Baxter equation is not restricted to only chemically heterogeneous surfaces, as air within porous homogeneous surfaces will make the system heterogeneous. However, if the liquid penetrates the grooves, the surface returns to homogeneity and neither of the previous equations can be used. In this case the liquid is in the Wenzel state, governed by a separate equation. Transitions between the Cassie-Baxter state and the Wenzel state can take place when external stimuli such as pressure or vibration are applied to the liquid on the surface.[6]

Equation origin edit

When a liquid droplet interacts with a solid surface, its behaviour is governed by surface tension and energy. The liquid droplet could spread indefinitely or it could sit on the surface like a spherical cap at which point there exists a contact angle.

Defining   as the free energy change per unit area caused by a liquid spreading,

 

where  ,  are the fractional area's of the two materials on the heterogeneous surface, and  and  the interfacial tensions between solid, air and liquid.

The contact angle for the heterogeneous surface is given by,

 , with  the interfacial tension between liquid and air.

The contact angle given by the Young equation is,

 

Thus by substituting the first expression into Young's equation, we arrive at Cassie's law for heterogeneous surfaces,

 [1]

History behind Cassie's law edit

Young's law edit

Studies concerning the contact angle existing between a liquid and a solid surface began with Thomas Young in 1805.[7] The Young equation

 

 
Different contact angle scenario's

reflects the relative strength of the interaction between surface tensions at the three phase contact, and is the geometric ratio between the energy gained in forming a unit area of the solid–liquid interface to that required to form a liquid–air interface.[1] However Young's equation only works for ideal and real surfaces and in practice most surfaces are microscopically rough.

 
Cassie's law

Wenzel state edit

In 1936 Young's equation was modified by Robert Wenzel to account for rough homogeneous surfaces, and a parameter   was introduced, defined as the ratio of the true area of the solid compared to its nominal.[8] Known as the Wenzel equation,

 

shows that the apparent contact angle, the angle measured at casual inspection, will increase if the surface is roughened. Liquids with contact angle  are known to be in the Wenzel state.

Cassie-Baxter state edit

The notion of roughness effecting the contact angle was extended by Cassie and Baxter in 1944 when they focused on porous mediums, where liquid does not penetrate the grooves on rough surface and leaves air gaps.[5] They devised the Cassie-Baxter equation;

 , sometimes written as   where the   has become  .[9]

Cassie's Law edit

In 1948 Cassie refined this for two materials with different chemistries on both smooth and rough surfaces, resulting in the aforementioned Cassie's law

 

Arguments and inconsistencies edit

Following the discovery of superhydrophobic surfaces in nature and the growth of their application in industry, the study of contact angles and wetting has been widely reexamined. Some claim that Cassie's equations are more fortuitous than fact with it being argued that emphasis should not be placed on fractional contact areas but actually the behaviour of the liquid at the three phase contact line.[10] They do not argue never using the Wenzel and Cassie-Baxter's equations but that “they should be used with knowledge of their faults”. However the debate continues, as this argument was evaluated and criticised with the conclusion being drawn that contact angles on surfaces can be described by the Cassie and Cassie-Baxter equations provided the surface fraction and roughness parameters are reinterpreted to take local values appropriate to the droplet.[11] This is why Cassie's law is actually more of a rule.

Examples edit

It is widely agreed that the water repellency of biological objects is due to the Cassie-Baxter equation. If water has a contact angle between  , then the surface is classed as hydrophilic, whereas a surface producing a contact angle between   is hydrophobic. In the special cases where the Contact angle is  , then it is known as superhydrophobic.

Lotus Effect edit

One example of a superhydrophobic surface in nature is the Lotus leaf.[12] Lotus leaves have a typical contact angle of  , ultra low water adhesion due to minimal contact areas, and a self cleaning property which is characterised by the Cassie-Baxter equation.[13] The microscopic architecture of the Lotus leaf means that water will not penetrate nanofolds on the surface, leaving air pockets below. The water droplets become suspended in the Cassie-Baxter state and are able to roll off the leaf picking up dirt as they do so, thus cleaning the leaf.

Feathers edit

The Cassie–Baxter wetting regime also explains the water repellent features of the pennae (feathers) of a bird. The feather consists of a topography network of 'barbs and barbules' and a droplet that is deposited on a these resides in a solid-liquid-air non-wetting composite state, where tiny air pockets are trapped within.[14]

See also edit

References edit

  1. ^ a b c Cassie, A. B. D. (1948). "Contact angles". Discussions of the Faraday Society. 3: 11. doi:10.1039/DF9480300011.
  2. ^ Henderson, J. R. (20 May 2000). "Statistical mechanics of Cassie's law". Molecular Physics. 98 (10): 677–681. Bibcode:2000MolPh..98..677H. doi:10.1080/00268970009483335. S2CID 95034874.
  3. ^ Milne, A.J.B.; Amirfazli, A. (January 2012). "The Cassie equation: How it is meant to be used". Advances in Colloid and Interface Science. 170 (1–2): 48–55. doi:10.1016/j.cis.2011.12.001. PMID 22257682.
  4. ^ Berthier, Jean; Silberzan, Pascal (2010). Microfluidics for biotechnology (2nd ed.). Boston: Artech House. ISBN 978-1-59693-444-3. OCLC 642685865.[page needed]
  5. ^ a b Cassie, A. B. D.; Baxter, S. (1944). "Wettability of porous surfaces". Transactions of the Faraday Society. 40: 546. doi:10.1039/tf9444000546.
  6. ^ Lopes, Daisiane M.; Ramos, Stella M. M.; de Oliveira, Luciana R.; Mombach, José C. M. (2013). "Cassie–Baxter to Wenzel state wetting transition: a 2D numerical simulation". RSC Advances. 3 (46): 24530. Bibcode:2013RSCAd...324530L. doi:10.1039/c3ra45258a.
  7. ^ "III. An essay on the cohesion of fluids". Philosophical Transactions of the Royal Society of London. 95: 65–87. January 1805. doi:10.1098/rstl.1805.0005. S2CID 116124581.
  8. ^ Marmur, Abraham (September 2003). "Wetting on Hydrophobic Rough Surfaces: To Be Heterogeneous or Not To Be?". Langmuir. 19 (20): 8343–8348. doi:10.1021/la0344682.
  9. ^ Scientific, Biolin. "Influence of Surface roughness on contact angle and wettability" (PDF).
  10. ^ Gao, Lichao; McCarthy, Thomas J. (March 2007). "How Wenzel and Cassie Were Wrong". Langmuir. 23 (7): 3762–3765. doi:10.1021/la062634a. PMID 17315893.
  11. ^ McHale, G. (July 2007). "Cassie and Wenzel: Were They Really So Wrong?". Langmuir. 23 (15): 8200–8205. doi:10.1021/la7011167. PMID 17580921.
  12. ^ Law, Kock-Yee (20 February 2014). "Definitions for Hydrophilicity, Hydrophobicity, and Superhydrophobicity: Getting the Basics Right". The Journal of Physical Chemistry Letters. 5 (4): 686–688. doi:10.1021/jz402762h. PMID 26270837.
  13. ^ Darmanin, Thierry; Guittard, Frédéric (June 2015). "Superhydrophobic and superoleophobic properties in nature". Materials Today. 18 (5): 273–285. doi:10.1016/j.mattod.2015.01.001.
  14. ^ Bormashenko, Edward; Bormashenko, Yelena; Stein, Tamir; Whyman, Gene; Bormashenko, Ester (July 2007). "Why do pigeon feathers repel water? Hydrophobicity of pennae, Cassie–Baxter wetting hypothesis and Cassie–Wenzel capillarity-induced wetting transition". Journal of Colloid and Interface Science. 311 (1): 212–216. Bibcode:2007JCIS..311..212B. doi:10.1016/j.jcis.2007.02.049. PMID 17359990.